![]() Once you have added new fluid up to the fill line of the reservoir, you can move to the final step of the brake fluid replacement job. Filling your car with the wrong fluid can decrease brake performance or even damage parts of your brake system. Always follow your manufacturer’s recommendation when selecting the right type of fluid. The most common types of fluid are DOT 3 and DOT 4 fluid, but some vehicles might require a special type of synthetic fluid. Your owner’s manual should specify the type of fluid to use. Next, you will want to refill your brake fluid reservoir with new brake fluid. Once you have completed this step, it’s time to add the new fluid! - Add New Fluid To System If you drip brake fluid anywhere, make sure to thoroughly clean it right away. Brake fluid is highly corrosive, and it will damage your paint almost immediately. Make sure that you are careful not to spill any of the brake fluid onto your vehicle. Wipe out the bottom of the reservoir to remove any dirt or debris that might be in there. You can then use an old rag or paper towel to finish removing the remaining fluid. Suction as much of the old fluid as possible out of the reservoir. A suction pump or even a turkey baster works well for this task. You will first need to remove all the old fluid from your brake fluid reservoir, which is usually located on top of the master cylinder. Here are the steps you should take to perform your own brake fluid flush. ![]() A partner is helpful but not required if you have the right tools. Flushing your brake fluid is not extremely difficult, especially if you have some mechanical knowledge. ![]() You can have an automotive repair shop perform a brake fluid flush on your vehicle, but you can also do the task yourself. However, bleeding the system to remove all the old fluid is crucial, and that step should always be done as part of a complete fluid change. Some people might perform a brake fluid change by simply removing the old fluid from the reservoir and refilling it with fresh fluid. A complete brake fluid change should remove all the old fluid from the lines and replace it with new fluid as well. That’s because it is! There is no real difference between a brake fluid flush and a brake fluid change when both are done properly. You might be thinking that this process sounds just like a brake fluid change. At a high level, the process involves removing all the old fluid from the brake fluid reservoir, refilling the reservoir with new brake fluid, and pushing the new fluid into the brake lines as the old fluid exits. Some auto repair shops use special tools to flush the fluid from the system, although it can also be performed with a few basic hand tools. Keeping new fluid in the system is crucial to keeping everything working properly and running smoothly.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |